Siemens Sinumerik 801 Technical Manual page 102

Technical Appendix
mm, deg Portion of distance for backlash working
_always 0,1
36610 AX_EMERGENCY_STOP_TIME
s Duration of the deceleration ramp for error states
_always 0.05
36620 SERVO_DISABLE_DELAY_TIME
s Cutout delay servo enable
_always 0.1
36700 DRIFT_ENABLE
– Automatic drift compensation
_always 0
36710 DRIFT_LIMIT
% Drift limit value for automatic drift compensation
_always 1.000
36720 DRIFT_VALUE
% Drift basic value
_always 0.0
38000 MM_ENC_COMP_MAX_POINTS
– Number of intermediate points for interpolatory
compensation (SRAM)
_always 0, 0
Setting data
41110 JOG_SET_VELO
mm/min Axis speed for JOG
_always 0.0
41200 JOG_SPIND_SET_VELO
rev/min Speed for spindle JOG mode
_always 0.0
43210 SPIND_MIN_VELO_G25
rev/min Progr. spindle speed limitation G25
_always 0.0
43220 SPIND_MAX_VELO_G26
rev/min Progr. spindle speed limitation G26
_always 1000
43230 SPIND_MAX_VELO_LIMS
rev/min Spindle speed limitation with G96
7-1
0.0
0.0
0.0
***
0.0
0
0.0
0.0
0.0
0.0
NEW CONF
plus
NEW CONF
plus
NEW CONF
plus
NEW CONF
***
NEW CONF
plus
NEW CONF
POWER ON
5000
Immediately
plus
Immediately
plus
Immediately
plus
Immediately
plus
Immediately
SINUMERIK 801
DOUBLE
DOUBLE
DOUBLE
BOOLEAN
DOUBLE
DOUBLE
DWORD
DOUBLE
DOUBLE
DOUBLE
DOUBLE
Start-Up