Charging The Battery - Symbol SPT 1700 Product Reference Manual

SPT 1700 Series Product Reference Guide

Charging the Battery

Before using your SPT 1700 for the first time, charge the lithium-ion battery. The terminal's
battery can be charged using the Cradle, the Synchronization/Charging Cable, or the
Universal Battery Charger (UBC). For instructions on using the UBC to charge your
batteries, refer to the Quick Reference Guide which came with your UBC. Follow these
same procedures to recharge the battery when the terminal's battery level is low.
Using the Cradle to Charge the Battery
To charge the terminal's battery using the CRD 1700 cradle:
1. Make sure the battery is installed in the terminal. Refer to
page 1-13 for instructions.
2. Make sure the cradle is plugged into a wall outlet.
3. Insert the SPT 1700 terminal in the cradle as shown:
Battery
Charging
LED
On the CRD1700-1000S, the battery charging LED turns red to indicate that the battery is
charging, then turns green after approximately two hours to indicate that the terminal's
battery is fully charged.
Spare Battery Charging
The CRD1700-1000S single-slot cradle has a spare battery charging slot which charges
the terminal's spare battery. Insert the battery in the spare battery charging slot in the back
of the cradle. The spare battery charging LED turns red to indicate the spare battery is
1-14
Installing the Battery on