Connect The Acx4000 Gateway To A Management Console Or Auxiliary Device; Connect Network Interface Cables To The Acx4000 Router - Juniper ACX4000 User Manual

Connect the ACX4000 Gateway to a Management Console or Auxiliary
Device
1. Turn off the power to the console or auxiliary device.
2. Plug the RJ-45 end of the serial cable
CONSOLE/AUX port on the front panel.
3. Plug the female DB-9 end into the device's serial port.

Connect Network Interface Cables to the ACX4000 Router

1. Have ready a length of the type of cable used by the network ports. For cable specifications, see the
ACX4000 Universal Access Routers Hardware
NOTE: Shielded cables are required for outside deployment.
2. Remove the rubber safety plug from the cable connector port.
WARNING:
fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected to a
transceiver emit laser light that can damage your eyes.
CAUTION:
or removing cable. The safety cap keeps the port clean and prevents accidental
exposure to laser light.
3. Insert the cable connector into the cable connector port on the faceplate.
4. Arrange the cable to prevent it from dislodging or developing stress points. Secure the cable so that it
is not supporting its own weight as it hangs to the floor. Place excess cable out of the way in a neatly
coiled loop.
(Figure 6 on page 13
Figure 1 on page 4
Guide.
Do not look directly into a fiber-optic transceiver or into the ends of
Do not leave a fiber-optic transceiver uncovered except when inserting
shows the connector) into the
shows the ports.
14