Safety Warnings - Juniper ACX4000 User Manual

Safety Warnings

WARNING:
of safety warnings. For a complete list of warnings for this router, including translations,
see the
https://www.juniper.net/documentation/.
WARNING:
intrabuilding or unexposed wiring or cabling only. The intrabuilding port(s) of the router
MUST NOT be metallically connected to interfaces that connect to the OSP or its wiring.
These interfaces are designed for use as intrabuilding interfaces only (Type 2 or Type 4
ports as described in GR-1089-CORE, Issue 4) and require isolation from the exposed
OSP cabling. The addition of primary protectors is not sufficient protection to connect
these interfaces metallically to OSP wiring.
CAUTION:
to an ESD point, and place the other end of the strap around your bare wrist. Failure to
use an ESD strap could result in damage to the router.
CAUTION:
Only trained and qualified personnel should install or replace the router.
Perform only the procedures described in this quick start or the
Hardware Guide. Other services should be performed by authorized service personnel only.
Read the installation instructions before you connect the router to a power source.
Before installing the router, read the guidelines for site preparation in the
Routers Hardware Guide
requirements for the router.
When installing the router, do not use a ramp inclined more than 10 degrees.
To prevent injury, keep your back straight and lift with your legs, not your back.
Mount the router at the bottom of the rack if it is the only unit in the rack.
See installation instructions before connecting the router. This is a summary
ACX4000 Universal Access Routers Hardware Guide
The intrabuilding port(s) of the router is suitable for connection to
Before removing or installing components of a router, attach an ESD strap
Use an external surge protective device (SPD) at the AC input of the router.
to make sure that the site meets power, environmental, and clearance
at
ACX4000 Universal Access Routers
ACX4000 Universal Access
25