Step 3: Ground The Acx4000 Router; Tools Required To Ground The Acx4000 Router; Connect The Grounding Cable - Juniper ACX4000 User Manual

Step 3: Ground the ACX4000 Router

IN THIS SECTION

Tools Required to Ground the ACX4000 Router | 10

Connect the Grounding Cable | 10

You must ground the router before connecting power.
Tools Required to Ground the ACX4000 Router
To ground the router, you need the following tools:
Phillips (+) screwdriver, number 2
ESD grounding wrist strap
Two SAE 10-32 screws and paint piercing washers (not provided)
Grounding lug, Panduit LCD06-10-A or equivalent (not provided)
Grounding cable, minimum 6 AWG (13.3 mm
Connect the Grounding Cable
You ground the router by connecting a grounding cable to earth ground and then attaching it to the chassis
grounding points. To ground the router:
1. Verify that a licensed electrician has attached the cable lug provided with the router to the grounding
cable.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
an approved site ESD grounding point. See the instructions for your site.
3. Ensure that all grounding surfaces are clean and brought to a bright finish before grounding connections
are made.
2
) 90° C wire (not provided)
10