Lexus LS 500 2019 Owner's Manual page 88

88
2-1. Instrument cluster
Displays the following items:
• Speedometer
• Shift position/shift range/gear position (
Tachometer/Eco Driving Indicator display area (P.90)
F
HUD (Head-up display) switch
G
Head-up display will operate when
■
The engine switch is in IGNITION ON
mode.
When using the head-up display
■
The head-up display may seem dark or hard
to see when viewed through sunglasses,
especially polarized sunglasses. Adjust the
brightness of the head-up display or
remove your sunglasses.
Street name display
■
Only street names which are included in the
map data will be displayed.
■ Outside temperature display
● When the ambient temperature is
approximately 37°F (3°C) or lower, the
low outside temperature indicator will
flash for approximately 10 seconds and
the outside temperature display will turn
off. In this case, the display will be dis-
played again when the outside tempera-
ture becomes approximately 41°F (5°C)
or higher.
● In the following situations, the correct
outside temperature may not be dis-
played, or the display may take longer
than normal to change:
• When stopped, or driving at low speeds
(less than 12 mph [20 km/h])
• When the outside temperature has
changed suddenly (at the entrance/exit of
a garage, tunnel, etc.)
When "--" or "E" is displayed, the system
●
may be malfunctioning. Take your vehicle
to your Lexus dealer.
LS500_OM_(U)_1810
P.167
)
WARNING
When using the head-up display
■
● Check that the position and brightness
of the head-up display image does not
interfere with safe driving. Incorrect
adjustment of the image's position or
brightness may obstruct the driver's
view and lead to an accident, resulting
in death or serious injury.
Do not continuously look at the
●
head-up display while driving as you
may fail to see pedestrians, objects on
the road, etc. ahead of the vehicle.
NOTICE
Head-up display projector
■
Do not place any drinks near the
●
head-up display projector. If the pro-
jector gets wet, electrical malfunctions
may result.
● Do not place anything on or put stick-
ers onto the head-up display projector.
Doing so could interrupt head-up dis-
play indications.
● Do not touch the inside of the head-up
display projector or thrust sharp edges
or the like into the projector.
Doing so could cause mechanical mal-
functions.