448
8-1. Specifications
Octane Rating
Fuel tank capacity
(Reference)
Lubrication system
Oil capacity (Drain and refill [Ref-
■
*
erence
])
2WD models
6.7 qt. (6.3 L, 5.5 Imp. qt.)
With filter
AWD models
7.5 qt. (7.1 L, 6.2 Imp. qt.)
2WD models
Without fil-
6.1 qt. (5.8 L, 5.1 Imp. qt.)
ter
AWD models
7.0 qt. (6.6 L, 5.8 Imp. qt.)
*
: The engine oil capacity is a reference
quantity to be used when changing the
engine oil. Warm up and turn off the
engine, wait more than 5 minutes, and
check the oil level on the dipstick.
Engine oil selection
■
"Toyota Genuine Motor Oil" is used in
your Lexus vehicle. Use Lexus
approved "Toyota Genuine Motor Oil"
or equivalent to satisfy the following
grade and viscosity.
Oil grade: ILSAC GF-5 multigrade
engine oil
Recommended viscosity: SAE 0W-20
SAE 0W-20 is the best choice for
good fuel economy and good starting
in cold weather.
If SAE 0W-20 is not available, SAE
5W-20 oil may be used. However, it
must be replaced with SAE 0W-20 at
LS500_OM_(U)_1810
91 (Research Octane Number 96) or higher
21.7 gal. (82.0 L, 18.0 Imp. gal.)
the next oil change.
Recommended viscosity (SAE):
Outside temperature
A
Oil viscosity (0W-20 is explained here
as an example):
• The 0W in 0W-20 indicates the
characteristic of the oil which allows
cold startability. Oils with a lower
value before the W allow for easier
starting of the engine in cold
weather.
• The 20 in 0W-20 indicates the vis-
cosity characteristic of the oil when
the oil is at high temperature. An oil
with a higher viscosity (one with a
higher value) may be better suited if
the vehicle is operated at high
speeds, or under extreme load con-
ditions.
How to read oil container label:
The International Lubricant Specifica-
tion Advisory Committee (ILSAC)
Certification Mark is added to some oil