Lexus LS 500 2019 Owner's Manual page 353

transmitter button at 2 second inter-
vals, repeatedly, until the HomeLink
indicator light changes from slowly
flashing (orange) to rapidly flashing
(green) (rolling code) or continuously
lit (green) (fixed code).
4
Test the HomeLink
pressing the newly programmed
button and observing the indicator
light:
 Indicator light illuminates: Program-
ming of a fixed code device has
completed. The garage door or
other device should operate when a
®
HomeLink button is pressed and
released.
 Indicator light flashes rapidly: The
garage door opener motor or other
device is equipped with a rolling
code. To complete programming,
firmly press and hold the Home-
®
Link button for 2 seconds then
release it.
 If the garage door or other device
does not operate, proceed to "Pro-
gramming a rolling code system".
5 Repeat the steps above to program
another device for any of the
remaining HomeLink
Programming a rolling code sys-
■
tem
2 or more people may be necessary to
complete rolling code programming.
1 Locate the "Learn" or "Smart" but-
ton on the garage door opener
motor in the garage.
This button can usually be found where the
LS500_OM_(U)_1810
5-6. Using the other interior features
hanging antenna wire is attached to the
unit. The name and color of the button may
®
vary by manufacturer. Refer to the owner's
manual supplied with the garage door
opener motor for details.
®
operation by
2
Press and release the "Learn" or
"Smart" button.
Perform
forming 2.
3
Press and hold the desired Home-
Link
for 2 seconds and release it. Repeat
this sequence (press/hold/release)
up to 3 times to complete pro-
®
gramming.
buttons.
If the garage door opener motor
operates when the HomeLink
button is pressed, the garage door
3
within 30 seconds after per-
®
button (inside the vehicle)
353
5
®