Lexus LS 500 2019 Owner's Manual page 437

connect a negative cable clamp to
clamp at the other end of the negative cable to
Exclusive jump starting terminal (your vehicle)
A
Positive (+) battery terminal (second vehicle)
B
Negative (-) battery terminal (second vehicle)
C
Solid, stationary, unpainted metallic point away from the exclusive jump starting
D
terminal and any moving parts as shown in the illustration
7
Start the engine of the second vehi-
cle. Increase the engine speed
slightly and maintain at that level for
approximately 5 minutes to
recharge the battery of your vehi-
cle.
8
Open and close any of the doors of
your vehicle with the engine switch
off.
9
Maintain the engine speed of the
second vehicle and start the engine
of your vehicle by turning the
engine switch to IGNITION ON
mode.
10 Once the vehicle's engine has
started, remove the jumper cables
in the exact reverse order from
which they were connected.
LS500_OM_(U)_1810
7-2. Steps to take in an emergency
on the second vehicle and connect the
C
.
D
11
Close the exclusive jump starting
terminal cover, and reinstall the fuse
box cover to its original position.
12 Install the service cover.(P.375)
13
Install the engine compartment
cover.
Once the engine starts, have the vehi-
cle inspected at your Lexus dealer as
soon as possible.
■ Starting the engine when the battery is
discharged
The engine cannot be started by push-start-
ing.
■ To prevent battery discharge
Turn off the headlights and the audio sys-
●
tem while the engine is off.
● Turn off any unnecessary electrical com-
ponents when the vehicle is running at a
437
7