LOG SET INSTALLATION
4. Install 2 log support plates onto the burner with 2 screws each as
shown.
Diagram 5—Install Log support plates
Log Support Plates
Diagram 6—Log support plates installed
5.
Place Log 1 onto the grate, behind the rear of burner. Ensure left cut
out of log butts up against end of burner tube and right end of log
butts up against curve of burner. Final position of the log should be
pulled forward and to the right while contacting the end and curved
parts of the burner.
Diagram 7—Log 1 installation
920-127
1
Page 2 of 4
6. Install Log 2 on left log support plate. Line up the pins on the plate
with the pin hole on the log.
2
Diagram 9—Install Log 2
7. Install Log 3 on right log support plate. Line up the pins on the plate
with the pin hole on the log.
2
Diagram 10—Install Log 3
Grandview® G800EC Gas Fireplace
installation
1
1
3
|
65
06.17.19