Mitsubishi 6M70 Workshop Manual page 318

Tightening torque (Unit: N·m {kgf·m})
Mark
Lock nut
Lubricant and/or sealant
Mark
Thread of lock nut
O-ring
Piston ring
Bearing
Removal procedure
Parts to be tightened
Points of application
• Secure the turbine housing in a vise.
• Fit the turbine wheel side of the cartridge assembly into the tur-
• Hold the boss on the shaft and turbine wheel unit to prevent the
• Loosen and remove the lock nut.
• If the measurement deviates from the standard value, replace
• Remove the snap ring.
CAUTION
• Remove the snap ring while holding it with your hand to
Tightening torque
Specified lubricant and/or sealant
Molykote BR-2 Plus
Removal: Compressor wheel
bine housing.
cartridge assembly from turning.
Inspection: Turbine housing-to-shaft and turbine wheel
clearance
the defective part.
Removal: Snap ring
prevent it from springing off.
20 {2.0}
Engine oil
15
Remarks
Thread-locking
compound
Quantity
As required
As required
15-45