Mitsubishi 6M70 Workshop Manual page 95

[Installation]
• Install until it contacts the PTO idler gear A with PTO idler
gear A facing in the illustrated direction.
• After installation, measure the clearance again.
• If the measurement is less than the standard value, ream the
bushing.
Inspection: Clearance between PTO idler gear bushing and
idler shaft C
[Inspection]
• If the clearance exceeds the limit, replace the bushing.
Replacement of PTO idler gear bushing
[Removal]
[Installation]
• Install until it contacts the PTO idler gear B with PTO idler
gear B facing in the illustrated direction.
• After installation, measure the clearance again.
• If the measurement is less than the standard value, ream the
bushing.
Inspection: Clearance between idler shaft C and idler gear
bushing
[Inspection]
• If the clearance exceeds the limit, replace the bushing.
11
11-85