Timing Gears Without Flywheel Pto Disassembly And Assembly - Mitsubishi 6M70 Workshop Manual

MITSUBISHI 6M70 TIMING GEARS
<WITHOUT FLYWHEEL PTO>
Disassembly sequence
1 Idler shaft C
2 Idler gear bushing
3 Idler gear C
4 Thrust plate C
5 O-ring
Assembly sequence
Follow the disassembly sequence in reverse.
Service standards (Unit: mm)
Location
– Backlash between gears
1, 2 Clearance between idler shaft C and idler gear bushing
3, 9 Idler gear end play
Clearance between idler shaft A, B and idler gear bush-
8, 10
ing
Tightening torque (Unit: N·m {kgf·m})
Mark
Bolt (idler gear C mounting)
Idler shaft bolt (idler gear A, B mounting)
11-78
6 Idler shaft bolt
7 Thrust plate A, B
8 Idler gear bushing
9 Idler gear A, B
10 Idler shaft A, B
Maintenance item
Idler gear C and supply
pump gear
Idler gear C and idler gear
A, B
Idler gear A, B and crank-
shaft gear
Parts to be tightened
* a: Supply pump gear
* b: Crankshaft gear
: Non-reusable parts
: Locating pin
Standard value Limit
0.096 to 0.198 0.35
0.089 to 0.181 0.35
0.076 to 0.196 0.35
0.036 to 0.08
0.1 to 0.2
0.025 to 0.066
Tightening torque
80 {8.0}
155 {16}
Remedy
Replace
Replace
Replace
0.2 Replace
0.4 Replace
0.2 Replace
Remarks
–
–