Radiator Disassembly And Reassembly - Mitsubishi 6M70 Workshop Manual

RADIATOR AND FAN SHROUD
Radiator
Disassembly sequence
1 Thrust rod bracket
2 Radiator shroud
3 Cross stay
4 Drain cock
CAUTION
• Gently handle upper tank and lower tank, since they are made of a resin that can break on impact.
• If there are two paint marks on the joint between the core and upper tank or on the joint between the core
and lower tank (which indicates that the tank retaining tabs have been crimped twice before), replace the
core with a new part.
• Do not disassemble radiator unless there is an abnormality.
Assembly sequence
Follow the disassembly sequence in reverse.
Service standards
Location
Air leakage from radiator
–
(air pressure: 177 kPa {1.8 kgf/cm
Tightening torque (Unit: N·m {kgf·m})
Mark
Drain cock
Bolt (side member mounting)
14-18
5 Side member
6 Upper tank
7 Packing
8 Lower tank
Maintenance item
2
})
Parts to be tightened
9 Packing
10 Core
: Non-reusable parts
Standard value Limit
3
0 cm {0 mL}
Tightening torque
2 {0.2}
13 {1.3}
Remedy
– Rectify or replace
Remarks
–
–