Mitsubishi 6M70 Workshop Manual page 310

Mitsubishi 6M70 Tightening torque (Unit: N·m {kgf·m})
Mark
Clamp
Eyebolt (oil pipe mounting)
Eyebolt (air pipe mounting)
Eyebolt (air pipe mounting)
Nut (turbocharger mounting)
Nut (turbocharger mounting)
Nut (turbocharger coupler bracket mounting)
Bolt (turbocharger magnetic valve bracket mounting)
Lubricant and/or sealant
Mark
Turbocharger (to be filled with engine oil)
Installation procedure
Mitsubishi 6M70 Engine Parts contact:
email: EngineParts@HeavyEquipmentRestorationParts.com
Phone: 269 673 1638
Parts to be tightened
Points of application
• Before installing the turbocharger assembly, pour engine oil into
• Fit the seal rings onto the turbocharger coupler, with their end
• Temporarily tighten the bracket on the air pipe and exhaust man-
• Tighten the bolts after temporary tightening while ensuring that
• After installing the bracket, ensure that there is no gas leakage
Tightening torque
7.0 to 8.0 {0.7 to 0.8}
Specified lubricant and/or sealant
Installation: Mitsubishi 6M70 Turbocharger
the oil hole of the bearing housing to ensure smooth operation of
the internal parts.
Installation: Mitsubishi 6M70 Seal ring
gaps positioned 180 degrees apart from each other.
Installation: Bracket
ifold.
there is no clearance at the joints between the bracket and air
pipe, and bracket and exhaust manifold.
from the joint of turbocharger with exhaust manifold.
21 {2.1}
25 {2.5}
36 {3.7}
45 {4.6}
90 {9.0}
75 {7.6}
Engine oil
15
Remarks
–
–
–
–
–
–
–
Quantity
As required
15-37