Memory Switch Setting Mode - Epson TM-T70II Technical Reference Manual

Memory Switch Setting Mode

You can configure the memory switches of the printer.
• Receive buffer capacity
• Processing when data receive error
• USB power-saving function
• Error signal output
• Multi-tone print density
• Character code table default
• Interface selection
• Auto paper reduction
• Buzzer control
• Communication condition of USB interface • TM-T70II command-compatible mode (only for ANK
For detailed information about memory switches, see
Enhancement" on page
Starting the memory switch setting mode
Follow the steps below to run this mode.
1 Close the roll paper cover.
2 Turn on the printer while pressing the Feed button. (Keep pressing the Feed button until
the printer starts printing.)
The printer prints current status of the printer.
With the LAN interface, before printing starts, it takes 6 seconds if the IP address is fixed and 13
seconds if the IP address is obtained with the automatic setting. (It may take longer depending
on the response time from the host.)
After the printing has been completed, press the Feed button for more than one second.
3
The printer starts printing instructions.
52
• BUSY condition
• Auto line feed
• Release condition of receive buffer BUSY
• Print density
• Print speed
• International character default
• Autocutting after closing cover
• Font auto replacement
• Communication condition of serial interface
models)
"Setting the Memory Switches/Receipt
32.