Epson TM-T70II Technical Reference Manual page 35

Multi-tone print density
Selectable from levels 1 to 13 (70% ~ 130%)
Initial setting for ANK models: level 7 (100%)
Initial setting for Simplified Chinese models, Traditional Chinese models, and South Asia font models: level 11
(120%)
• First change the print density, and then configure the Multi-tone print density.
• If you set the density too high, the contrast becomes lower. Select the density level checking
the overall tone balance of your image.
Print speed
Selectable from levels 1 to 13 (Slow ~ Fast)
Initial setting: level 13
Depending on print conditions, such as print duty, print head temperature, and data transmission
speed, print speed is automatically adjusted, which may cause white lines due to intermittent
print (the motor sometimes stops). To avoid this, keep the print speed constant by setting it
lower, or set the transmission speed higher for the serial interface.
Thai character print mode (only for South Asia font models)
• Thai 3 pass
• Thai 1 pass (initial setting)
Selecting the number of head energizing parts
• One-part energizing (initial setting)
• Two-part energizing
• Usually, the number of head energizing parts does not need to be changed.
• When printing at the maximum speed, select "One-part energizing. "
Character code table default
Selectable from 43 pages including user defined page
Initial setting: Page 0 (PC437: USA, Standard Europe)
• For the character code table, see
• User-defined page is not supported by South Asia font models.
"Character Code Tables" on page
Chapter 2 Setup
101.
35
2