Installing The Printer - Epson TM-T70II Technical Reference Manual

Installing the Printer

You can install this printer only horizontally.
Fix the printer so that it does not move around when you open the roll paper cover and cut roll paper. A tape for
fixing the printer is available as an option. (See
As shown in the figure below, install the printer with a maximum tilt of 3°.
Installing the printer with a tilt of more than 3° may cause the following problems.
• Roll paper near end cannot be detected.
• The roll paper cover will not close after installing roll paper.
• Roll paper cannot be taken out.
If the printer installation does not fit within the specifications shown in the figure below, the following
problems may occur.
• Cannot set the roll paper in the printer
• Cannot cut the paper with the manual cutter
Range that manual cutting is possible
Area required for loading the roll paper
(diameter: 83 mm)
22
"Affixing Position of DF-10" on page
Within
± 3°
Shelf height: 150 mm
Shelf height: 140 mm
60° or more
Shelf height: 127 mm
Manual cutter
7.5 mm
23.)
Within
± 3°
Horizontal