Epson TM-T70II Technical Reference Manual page 34

USB power-saving function
• Disabled
• Enabled (initial setting)
The USB power-saving function is valid only when the USB interface communication condition is
set to the vendor-defined class and the system configuration is set so that the USB driver can
support the USB power-saving function.
Release condition of receive buffer BUSY
• Releases when the remaining receive buffer capacity becomes 256 bytes (initial setting)
• Releases when the remaining receive buffer capacity becomes 138 bytes
This function is enabled only when Receive buffer capacity is set to 4 KB.
Paper sensor to output paper-end signals default (only for parallel
interface models)
• Paper end sensor enabled, paper near-end sensor enabled
• Disabled (initial setting)
Error signal output
• Enabled (initial setting)
• Disabled
Print density
Selectable from levels 1 to 13 (70% ~ 130%)
Initial setting: level 7 (100%)
Depending on the paper type, it is recommended to set the print density as shown in the table below for the best
print quality.
Original Paper type
TF50KS-E, P220AGB-1, AF50KS-E
TF60KS-E, PD160R, PD190R, KT48F20, KT55F20, F5041
P300, P310, P350
When the print density level is increased, printing speed may be reduced.
34
Density Level
Level 5 (90%)
Level 7 (100%)
Level 8 (105%)