Connecting The Cash Drawer; Connecting The Drawer Kick-Out Cable - Epson TM-T70II Technical Reference Manual

Connecting the Cash Drawer

Use the cash drawer handled by EPSON or your dealer.

Connecting the Drawer Kick-out Cable

• Specifications of drawers differ depending on makers or models. When you use a drawer
WARNING
• Use a shield cable for the drawer connector cable.
• Two driver transistors cannot be energized simultaneously.
• Leave intervals longer than 4 times the drawer driving pulse when sending it
• Be sure to use the printer power supply (connector pin 4) for the drawer power source.
• Do not insert a telephone line into the drawer kick connector.
Connect the connector of the drawer kick-out cable to the printer.
other than specified, make sure its specification meets the following conditions.
Otherwise, devices may be damaged.
∗ The load, such as a drawer kick-out solenoid, must be connected between pins 4 and 2 or
pins 4 and 5 of the drawer kick connector.
∗ When the drawer open/close signal is used, a switch must be provided between drawer kick
connector pins 3 and 6.
∗ The resistance of the load, such as a drawer kick-out solenoid, must be 24 Ω or more or the
input current must be 1 A or less.
∗ Be sure to use the 24 V power output on drawer kick connector pin 4 for driving the equip-
ment.
continuously.
Doing so may damage the telephone line or printer.
Chapter 2 Setup
2
45