Rinnai RDT-62-RM-W Operating Instructions Manual page 49

Gas clothes dryer

Table of Contents

Cause

There is too much washing loaded in the equipment.

The electrical circuit of a motor, etc. is malfunctioning.

Thin clothes with poor permeability or a mat is

covering the lint filter.

The discharge tube is blocked.

The electrical circuit of a motor, etc. is malfunctioning.

This occurs, for example, when the gas cock is

closed or was not completely open.

There is too much washing loaded in the equipment.

The electrical circuit of a motor, etc. is malfunctioning.

This occurs when there is insufficient air for

combustion.

Lint has accumulated on the lint filter or the lint filter

is blocked with lint.

Thin clothing with poor permeability is covering the

lint filter.

There is too much washing loaded in the equipment.

This occurs when dust has built up inside of the

equipment.

The discharge tube is blocked.

This occurs when there is insufficient air for

combustion.

Lint has accumulated on the lint filter or the lint filter

is blocked with lint.

Thin clothing with poor permeability is covering the

lint filter.

There is too much washing loaded in the equipment.

The discharge tube is blocked.

This occurs when an electrical circuit short-circuits.

Wait for the equipment to stop automatically before performing operation again. Repair is required when the safety interlock

operates again. Contact the store of purchase or call Customer Services Hotline.

Remedy

Reduce the amount of washing, and perform operation again. (as a

guideline after spin drying, within 9 kg)