Rinnai RDT-62-RM-W Operating Instructions Manual page 43

Caution
• Note that the lint filter is hot immediately after operation ends.
Cleaning the Lint Filter (every time after use)
The fi lter cleaning lamp lights or blinks when too much lint has accumulated on the lint fi lter. This increase the drying
time or may cause the inside of the equipment to overheat. So, be sure to clean the lint fi lter after drying ends.
1 Press the lint pocket knob and draw out
the lint fi lter (set) towards you.
The lint fi lter set comprises two parts, a lint
pocket and a fi lter. (See page 20.)
2 Remove the fi lter by holding the fi lter
knob between your fi ngers.
Press the fi lter knob between your fi ngers and
remove the lint pocket.
3 Remove lint from the fi lter lint pocket.
In the case of
stubborn dirt
4 Set the fi lter and lint pocket in place.
5 Set the lint fi lter (set) in place.
Press the lint pocket knob between your fi ngers.
Push in the lint fi lter until you hear it click into place.
• Wash in water with neutral detergent for kitchen use.
Thoroughly remove any water and allow the lint filter to
dry sufficiently before setting it in place.
• Be sure to set the lint filter in place after cleaning.
Filter knob
Lint pocket knob
Lint filter (set)
Lint pocket
(light blue)
Filter (black)
Soft toothbrush
Lint pocket
Filter
Clicks in
place
42 42