Rinnai RDT-62-RM-W Operating Instructions Manual page 29

2
Press
Select the operation course to match the type of
clothes. (See page 25.)
Press
3
Lights (green)
Short beep
After about 5 to 10 seconds
4 When the buzzer sounds, remove the clothes.
When drying operation ends, the buzzer sounds (three continuous beeps).
Before opening the front door, make sure that the operation/combustion
lamp is out, the FINISH lamp is lit (green) and the SOFTEN&COOL lamp is
blinking or is lit (green).
Caution
• Wait for the drum to come to a complete stop before removing clothes.
• Note that the lint filter and the area around the clothes removal port is hot immediately after operation ends.
Information
• Cool operation begins after one minute if clothes are not taken out. Also, to lower the temperature inside the drum after removing clothes,
close the front door and resume cool operation after approximately two minutes. Operation automatically stops when cool operation ends.
• If drying operation is continued immediately after cooling operation, drying operation begins immediately after cooling operation of two minutes
maximum.
• For details on how to stop cool operation, see pages 29 and 35.
and select the course.
Short beep
.
Lights (red)
Information
• Each press switches the course as follows.
• The course can be switched even during operation.
When the course is switched during operation,
drying operation starts with the new course that you
switched to after cooling operation of two minutes
maximum.
Information
• blinks for approximately two minutes until the
estimated remaining time is displayed.
• If the or switch is pressed during operation,
the drum stops. If the equipment is left in this state
for approximately two minutes, drying operation is
stopped, and cool operation is started.
(3 beeps)
28