Rinnai RDT-62-RM-W Operating Instructions Manual page 33

2
Press
Short beep
Information
• The timer operation time can be set within the range 5 to 90 minutes. (5 to 30 minutes can be set in 5-minute increments, and 30 to 90 minutes
can be set in 10-minute increments.)
• To cancel timer operation, press
3
Press
Goes out Lights (green)
When the buzzer sounds, remove the clothes.
4
When drying operation ends, the buzzer sounds (three continuous beeps).
Before opening the front door, make sure that the operation/combustion
lamp is out, the FINISH lamp is lit (green) and the SOFTEN&COOL lamp is
blinking or is lit (green).
Caution
• Wait for the drum to come to a complete stop before removing clothes.
• Note that the lint filter and the area around the clothes removal port is hot immediately after operation ends.
Information
• Cool operation begins after one minute if clothes are not taken out. Also, to lower the temperature inside the drum after removing clothes,
close the front door and resume cool operation after approximately two minutes. Operation automatically stops when cool operation ends.
• If drying operation is continued immediately after cooling operation, drying operation begins immediately after cooling operation of two minutes maximum.
• For details on how to stop cool operation, see pages 29 and 35.
and , and set the timer time.
Lights (green)
Blinks (green)
. Timer operation cannot be stopped even by pressing
.
Short beep
After about 5 to 10 seconds
Short beep
Each press switches the time
Information
Lights (red)
• If the
the drum stops. If the equipment is left in this state
for approximately two minutes, drying operation is
stopped, and cool operation is started.
.
or switch is pressed during operation,
(3 beeps)
Short beep
32