Advertisement
3 SETUP
3.1
3.2
3.3
6
Transport mode
H02712-01
Diagnostic connection
F01879-10
Unpacking and setting up the vehicle
E00851-10
This vehicle was blocked for transport in the software.
To operate the vehicle, the vehicle electronics must be enabled.
This process is conducted during initial setup in KTM Dealer.net.
Enabling ensures that the initial setup in KTM Dealer.net is docu-
mented.
Enabling can be performed either temporarily, e.g. for a test ride,
or permanently for vehicle handover.
Info
Make sure that the vehicle is permanently enabled before
handing it over to the customer.
1
Diagnostic connection
is located under the front rider's seat.
Info
The charging socket is also the diagnostic connection.
–
Remove the box and the plastic packaging.
Info
An assistant prevents the motorcycle from falling over.
To avoid damaging the motorcycle during the setup,
leave the protective film on the vehicle until you have
finished.
–
Remove and unpack the separate enclosure and components.
Check that the scope of supply is complete using the enclosed
packing list.
Info
The procedure in the event of missing components is
described in the customer service manual.
–
To be in compliance with the homologation of the vehicle,
mount all of the parts in the separate enclosure when assem-
bling the vehicle.
Info
It is not necessary to mount all of the parts in the sepa-
rate enclosure for the vehicle to operate correctly. How-
ever, homologation will not apply if not all parts from
the separate enclosure are mounted.
–
Remove the KTM PowerPack.
(
p. 29)
Advertisement
