Advertisement
3 SETUP
14
–
Drill a hole at marking
F01868-10
–
Route the turn signal cable harness through the frame from
the front to the rear paying attention to the plugs as you do so.
F01869-10
–
Join the turn signal cable harness plug-in connector to the
main wiring harness plug-in connector.
–
Position the battery compartment and mount and tighten
bq
screws
.
Info
The wiring harness runs under the battery compart-
ment.
–
Lock the seat.
F01865-10
–
Route the turn signal cable on the left side on the license
plate holder and feed the turn signal cable through the hole.
–
Route the cable of the tail light on the right side on the license
plate holder.
F01878-10
–
Position the license plate holder on the rear.
Info
Ensure that the cable is routed correctly.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
F01876-10
–
Position the tail light on the license plate holder.
–
Mount and tighten screws
A
to the size of the marking.
(
p. 22)
br
.
M6
10 Nm (7.4 lbf ft)
bs
.
Advertisement
