KTM Freeride E-XC 2019 Setup Instructions page 28

4 WORK
26
Main work
–
1
Remove charging socket protection cap.
Warning
Risk of injury The intrinsic safety of the
KTM PowerPack can only be guaranteed if the original
battery charger is used.
The KTM PowerPack may only be charged with the
original battery charger.
–
Only use the original battery charger to charge the
KTM PowerPack.
–
Connect the battery charger to the KTM PowerPack. Observe
plug markings
C00815-10
–
Connect the power plug for the battery charger to the mains
connection.
–
Set the charging mode switch
mal position.
Info
In charging mode Fast, the KTM PowerPack is com-
pletely charged after approx. 105 minutes. The power
consumption is higher than in charging mode Normal.
C00768-10
In charging mode Normal, the KTM PowerPack is com-
pletely charged after approx. 135 minutes.
–
Switch on the battery charger using switch
Charging starts automatically. The status indicator flashes
during the charging process.
C00769-10
–
Monitor the charging level of the KTM PowerPack using the
LEDs.
LED 1: 20 %
LED 2: 40 %
C00770-10
A
.
2
to the Fast position or Nor-
3
.