Table of Contents
Advertisement
TRENDnet User's Guide
Model Differences
TEW-840APBO
Single Unit Model
The single access point requires another TRENDnet TEW-840APBO or a TEW-841APBO
to create a WDS link.
Important Note:
Purchasing this model requires the access points to be properly configured to establish
the wireless link/bridged connection to each other and verifying connectivity first before
mounting the access points in their desired locations.
Single Unit Default Settings
LAN IP Address: 192.168.10.100
LAN Subnet Mask: 255.255.255.0
Channel Access Method: CSMA/CA
Mode: Access Point (AP) Mode
WPA2 Encryption Key: <predefined>
User: admin
Password: admin
TEW-840APBO2K
Preconfigured Bridge Kit Model
The two access points in the kit model are preconfigured to establish a WDS bridged
connection to each using a unique WPA2 encryption key. For convenience, a unique
predefined administrator password is also assigned. The predefined WPA2 encryption
key and administrator password can be found on the included wireless settings sticker
or on the device label.
Important Note:
Purchasing this model does not require any additional configuration to establish the
wireless link/bridged connection between the two access points but it is strongly
recommended that you verify connectivity first between the two access points first
before mounting them in their desired locations.
© Copyright 2019 TRENDnet. All Rights Reserved.
Preconfigured Kit Default Settings
TEW-840APBO #1
LAN IP Address: 192.168.10.50
LAN Subnet Mask: 255.255.255.0
Channel Access Method: TDMA
Mode: WDS Access Point Mode
WDS WPA2 Encryption Key: <predefined>
User: admin
Password: <predefined>
Wireless Setting Stickers for Kit TEW-840APBO2K
TEW-840APBO / TEW-840APBO2K
TEW-840APBO #2
LAN IP Address: 192.168.10.51
LAN Subnet Mask: 255.255.255.0
Channel Access Method: TDMA
Mode: WDS Station Mode
WDS WPA2 Encryption Key: <predefined>
User: admin
Password: <predefined>
7
Hide quick links:
Advertisement
Table of Contents
