Table of Contents
Advertisement
TRENDnet User's Guide
Pole Mount Installation
1. Reinstall the cover by lining up the guides into the notches as shown and push until
the cover clips into place and is secured. The cover includes cable openings to route
the connected Ethernet cable(s) when installing.
2. Insert the included fasteners through the holes located at the back of the access
point.
© Copyright 2019 TRENDnet. All Rights Reserved.
3. Wrap the fasteners around the pole where the access point will be installed. On the
fasteners, insert the open end into the locking mechanism and pull tight until the
point is secured.
Note: When set to WDS station mode, the TEW-840APBO features WiFi signal strength
connectivity LEDs located on the back of the access point to assist in determining the
optimal mounting position. (Red = Good, Orange = Better, Green = Best)
4. After the access points are properly mounted RJ-45 cables from each access point
PoE injector to your network.
TEW-840APBO / TEW-840APBO2K
16
Hide quick links:
Advertisement
Table of Contents
