Confirm Connectivity - TRENDnet TEW-840APBO User Manual

TRENDnet User's Guide

Confirm Connectivity

1. Leave your computer connected to TEW-840APBO #2 and keep the access point
management page open.
2. Make sure both TEW-840APBO #1 and TEW-840APBO #2 access point are powered
on and approximately 15 ft. (5 m) apart from one another with the front of access
points directly facing each other.
© Copyright 2019 TRENDnet. All Rights Reserved.
3. To verify connectivity, in the TEW-840APBO #2 access point management page,
Click on the Tools tab under Management category in the left hand menu.
4. The first tab, Ping, will automatically be selected. In the Target IP/Domain Name
field, enter the IP address 192.168.10.50. Then click Ping. The first tab, Ping, will
automatically be selected. In the Target IP/Domain Name field, enter the IP address
192.168.10.50. Then click Ping.
5. Ping replies and 0% packet loss will indicate a successful WDS point to point bridge
has been established between the two access points as shown below.
6. You can also check the status of the wireless point to point bridge between the two
access points in the Connections tab under Overview category in the left hand
menu.
Note: If the connectivity test fails, wait for about 1 minute and try again. Make sure
there are no obstacles between two access points and that they are not too close
together.
TEW-840APBO / TEW-840APBO2K
15