Tew-840Apbo Setup & Installation; Note The Wifi Mac Addresses - TRENDnet TEW-840APBO User Manual

TRENDnet User's Guide
TEW-840APBO Setup & Installation
The following installation procedure assumes you are setting up and installing two
TRENDnet TEW-840APBO access points using TDMA channel access method in WDS
Access Point/Station point-to-point configuration. For more information, please see
"Channel Access Method" on page 25.
Note: This example installation procedure will be demonstrated using the following
example network information:
Example Router Settings:
Router/Default Gateway IP Address: 192.168.10.1
Subnet Mask: 255.255.255.0
Using the above information, we will configure the TEW-840APBO access points
will be configured with the following settings:
IP Address
Netmask (Subnet Mask)
IP Gateway (Default Gateway)
Primary DNS
Wireless Channel (Default)
Channel Access Method
Mode
WDS Encryption
Note: In this installation procedure example, we will assume the WiFi MAC addresses:
WiFi MAC Address
© Copyright 2019 TRENDnet. All Rights Reserved.
TEW-840APBO #1 TEW-840APBO #2
192.168.10.50 192.168.10.51
255.255.255.0 255.255.255.0
192.168.10.1 192.168.10.1
192.168.10.1 192.168.10.1
48 48
TDMA TDMA
WDS Access Point WDS Station
WPA2 WPA2
TEW-840APBO #1 TEW-840APBO #2
00:11:22:33:44:00 00:11:22:33:44:11

Note the WiFi MAC Addresses

1. Remove the cover of the access points by pulling and holding the tab outwards (as
shown in the picture below) and sliding the cover downwards, away from the
access point.
2. Write down the WiFi SSID, WPA2 Key, and WiFi MAC address of each access point.
The MAC address can be found on the back label, and the SSID and WPA2 Key can
be found on the inside of the device cover where the Ethernet LAN ports are
located (pictured below).
TEW-840APBO / TEW-840APBO2K
8