TRENDnet TEW-840APBO User Manual page 6

TRENDnet User's Guide

LAN1 LED – When the LED is ON, this indicates an active network connection to
the LAN port on the proprietary PoE injector. When the LED is BLINKING, this
indicates data is being transmitted or received on the LAN1 port. The LED is
OFF when there is no active network connection to the LAN port on the
proprietary PoE injector.

LAN2 LED - When the LED is ON, this indicates an active network connection to
the LAN2 port. When the LED is BLINKING, this indicates data is being
transmitted or received on the LAN2 port. If the LED is OFF, there is no active
network connection to the LAN2 port.

WLAN LED – When the LED is ON, the wireless radio on the device is on. When
the LED is OFF, the wireless radio on the device has been disabled.

Connection Quality Indicators (WDS station only) – These LEDs will indicate
the wireless connection quality to the WDS Access Point when in WDS station
mode.

Reset Button – The reset button resets the access point to factory default
settings. Using a paper clip, push and hold the reset button for 15 sec. and
release. The LEDs will flash when the device reset has been initiated.

PoE Power Adapter Reset Button – The included PoE injector also has a reset
button to reset the access point to factory default. Using a paper clip, push and
hold the reset button for 15 sec. and release. The LEDs will flash when the
device reset has been initiated.
Important Note:
It is recommended to use RJ-45 cables without any additional caps, molded caps, or
boots specifically on the connector side that will be connected to the access point LAN1
(PoE) port to avoid any cable fitment issues inside the access point enclosure.
© Copyright 2019 TRENDnet. All Rights Reserved.

Proprietary PoE Power Adapters
Important Note:
The access point does not support standard IEEE 802.3at/af PoE/PoE+. Only the
included proprietary PoE injector may be used to supply power to the access point. For
safety, use only the included PoE injector to supply power to the access point.
o
POWER IN – Connect the included power cord to this input and the other end
into an AC power source to supply power to the injector.
o
PoE – Connect an Ethernet RJ-45 cable to this output and the other side to the
device LAN1 (PoE) port to supply power to the device. Please note that the RJ-
45 Ethernet cable between the proprietary PoE injector and the LAN1 (PoE)
port of the access points supports a maximum length of up to 60 m (197 ft.). RJ-
45 Ethernet cables longer than the maximum length specified may result in
insufficient power to the device, intermittent connectivity/power loss, and
unstable physical link.
o LAN – Connect an Ethernet RJ-45 cable to this input and connect the other to
your network or directly to a computer for initial device setup.
TEW-840APBO / TEW-840APBO2K
4