Furuno FAR-2107 Series Service Manual page 434

55. How to connect the EG-3000
See page.6-49.
Make the setting as follows:
- Select "EG" in [Menu] -> 0 -> 8 -> 2:DEMO ECHO.
- Select a type other than "IMO" in [Menu] -> 0 -> 4 -> 7:TYPE.
- Adjust R401 so that the level of TP58 is 2 Vp-p.
In the DEMO, the GAIN and A/C SEA cannot adjust.
56. How to set "Video Channel" on the VDR side
See page.4-55 and 4-57.
The setting list of VDR is shown in page.4-57. The setting on the radar side
should be made on jumpers on the RGB BUFF board. DVI I/F board, RGB
BUFF board and BNC connector converter are required to connect the VDR.
57. How to update a program
See Chapter 5.
Never turn off the power during updating a program, and never cancel updating
halfway. Connect the PC to the RS-232C port of RPU-013 to update a program.
Use a 9 pin D-sub cross cable (female-female) to connect the PC to RPU-013.
All programs can be updated in the same procedure. Click an applicable batch
file and follow instructions displayed on the PC. COM-1 is specified as the
updating port in the program batch file. If the serial port of the PC is other than
COM-1, change the COM port number in the batch file and overwrite so that the
port number of the PC agrees with the port number specified in the batch file.
58. What boards can be used commonly for X-band and S-band?
See page.5-2 and 6-37 to 6-39.
The list of boards is shown in page.6-37 to 6-39. The SPU board can be
commonly used. For boards of Ver-22 or later, the SPU FPGA program can be
updated from the PC as well as the main program. Programs of the SPU Ver-014
or later support this function.
59. What are components needing periodic replacement?
See page.6-42, 6-48 and 2-14.
Magnetron, Antenna motor, Motor brush and Battery of GC-10 need periodic
replacement.
8-14
Q & A