Furuno FAR-2107 Series Service Manual page 187

1 BACK
2 OWN SHIP MARK
3 STERN MARK
4 INDEX LINE BEARING
2 [MARK]
5 INDEX LINE
6 INDEX LINE MODE
7 [INS MARK]
7 [BARGE MARK]
8 EBL OFFSET BASE POINT
9 EBL CURSOR BEARING
9 [EBL VRM, CURSOR SET]
0 RING
Sets whether to display the own ship mark or not. The own
ship mark corresponds to the dimensions of the own ship.
The size of the own ship mark is set in [Menu] -> 0 -> 5 ->
2: LENGTH/WIDE and "REF POINT" is calculated from
the values set in [Menu] -> 0 -> 4 -> 5: RADAR POS and
[Menu] -> 0 -> 5 -> 6: CONNING POS.
If the own ship mark gets smaller than 6 mm on the screen,
it will be represented with a small dot.
Note:
The own ship mark can be changed by specifying the
OWN SHIP MARK in [MARK] box menu -> 2
Sets whether to turn on or off the stern mark. The stern
mark appears opposite to the heading line in a dot line.
Sets whether to display the bearing of the parallel index
line by the true bearing (T) or relative bearings (R.)
Parallel index line:
Two index lines (IL) are available. To adjust the index
line interval and bearing, place the cursor on IR and
make adjustments by EBL and VRM.
Specifies the number of index lines. When one (1) is
selected, "6.INDEX LINE MODE" as listed below is not
displayed.
When "VERTICAL" is selected, you can draw a line
perpendicular to the index line. "HORIZONTLA" is used
to erase a vertical line.
This menu box is displayed when "SERAL, LAN" is set on
[Menu] -> 0 -> 8 -> 5:INS.
This setting turns on or off the USER CHART, MARK,
LINE, ROUTE and NOTE BOOK from the INS.
This menu box is displayed when [Menu] -> 0 -> 8 -> 5:
INS is set to "OFF."
Allows the setting of the BARGE MARK and turning on
and off of the display.
Allows the setting of EBL offset.
This is a menu for IMO and A type radars.
This menu is for B and C type radars.
The unit of the VRM and the cursor range can be selected
from NM, SM, km and kyd.
Sets whether to display the range ring or not.
3-22
3.3 Main Menu Tree