Furuno FAR-2107 Series Service Manual page 43

11. Replace the cable between J802 on the RFC Board and J812 on the MD
Board with NH-XH connector (03-2150, supplied).
12. Fasten the RFC cover on the RFC Board as follows:
a) Set RFC cover to the RFC Board.
b) Fasten the cover with two spacers (SQ-15, supplied) for fixing holes at
back side and five screws and washers (unfastened at step 5) for
remaining fixing holes. (You may discard unused screws and washers.)
c) Fasten the grounding clamp attached at step 9 with the screw at the
center-bottom of the RFC cover.
13. Re-attach the connector to J803.
J803
Attaching the shield foam
14. Remove the IF AMP Board cover, and attach the shield foams (71TS-5-1,
supplied) as below.
1: 170 mm
2: 90 mm
15. Re-mount the IF AMP Board cover.
Use the screw to fasten the
grounding clamp.
1
2
1
3
Use the Spacers Supplied
2