Adjusting The Parking Brake - Toro Workman HDX Series Operator's Manual

Figure 59
1. Brake-fluid reservoir
6. If the fluid level is low, clean the area around
the cap, remove the reservoir cap, and fill the
reservoir to the proper level with the specified
brake fluid (Figure
Note:
Do not overfill the reservoir with brake
fluid.
Adjusting the Parking
Brake
Service Interval: After the first 10 hours
Every 200 hours
1. Remove the rubber grip from the parking-brake
lever (Figure 60).
Figure 60
1. Grip
2. Loosen the set screw securing the knob to the
parking-brake lever
59).
2. Parking-brake lever
(Figure 61).
1. Knob
2. Set screw
g002379
3. Rotate the knob
to 22 kg (45 to 50 lb) is required to actuate the
lever.
4. Tighten the set screw when finished
Note:
If you can no longer make a parking-brake
adjustment by adjusting the parking-brake
lever, loosen the handle to the middle of the
adjustment and adjust the cable at the rear, then
repeat step 3.
5. Install the rubber grip onto the parking-brake
lever (Figure
g033487
51
Figure 61
3. Parking-brake lever
(Figure 61) until a force of 20
60).
g033488
(Figure 61).