Inspecting Fuel Lines And Connections; Electrical System Maintenance; Electrical System Safety; Servicing The Fuses - Toro Workman HDX Series Operator's Manual

3. Loosen the hose clamp and disconnect the fuel
line from the fuel-pump cap
Figure 40
1. Fuel pump
2. Hose clamp
4. Remove the fuel-pump cap from the top of the
fuel tank (Figure
Important:
Do not allow the fuel-pump
assembly to rotate in the tank while removing
the fuel pump. Damage to the float assembly
can occur if the fuel pump rotates inside the
fuel tank.
5. Remove the fuel-pump assembly and the fuel
filter from the tank
6. Remove the clamp securing the fuel filter hose
to the fuel-pump fitting.
7. Remove the hose from the fitting
8. Insert the new hose clamp onto the new
fuel-filter hose.
9. Insert the hose onto the fuel pump and secure
the clamp.
10. Insert the assembly into the fuel tank, and
tighten the cap to 20 to 22 N∙m (175 to 200 in-lb).
11. Connect the wires and secure the hose with the
hose clamp.
Inspecting Fuel Lines and
Connections
Service Interval: Every 400 hours/Yearly (whichever
comes first)
Inspect the fuel lines, fittings, and clamps for signs of
leaking, deterioration, damage, or loose connections.
Note:
Repair any damaged or leaking fuel system
component before using the machine.
(Figure 40).
3. Fuel line/fuel filter
40).
(Figure 40).
(Figure
Electrical System
Maintenance

Electrical System Safety

•
Disconnect the battery before repairing the
machine. Disconnect the negative terminal first
and the positive last. Connect the positive terminal
first and the negative last.
•
Charge the battery in an open, well-ventilated
area, away from sparks and flames. Unplug the
charger before connecting or disconnecting the
battery. Wear protective clothing and use insulated
g010330
tools.

Servicing the Fuses

The fuses for the electrical system are located under
the center of the dash panel
40).
1. Fuses
42
(Figure 41 and Figure
Figure 41
42).
g010328