Changing The Front Differential Oil; Inspecting The Constant-Velocity Boot; Adjusting The Shift Cables - Toro Workman HDX Series Operator's Manual

Changing the Front
Differential Oil
4-Wheel Drive Models Only
Service Interval: Every 800 hours (4-wheel drive
models only).
Differential oil specification: Mobil 424 hydraulic
fluid
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key.
4. Clean the area around the drain plug on the side
of the differential
5. Place a drain pan under the drain plug.
6. Remove the drain plug and let the oil flow into
the drain pan.
7. Install and tighten the plug when the oil stops
draining.
8. Clean the area around the fill/check plug on the
bottom of the differential.
9. Remove the fill/check plug and add specified oil
until the oil level is up to the hole.
10. Install the fill/check plug.
(Figure 45).
Inspecting the
Constant-Velocity Boot
4-Wheel Drive Models Only
Service Interval: Every 200 hours (4-wheel drive
models only).
Inspect the constant-velocity boot for cracks, holes,
or a loose clamp. Contact your Authorized Service
Dealer for repair if you find any damage.

Adjusting the Shift Cables

Service Interval: After the first 10 hours
Every 200 hours
1. Move the shift lever to the N
2. Remove the clevis pins securing the shift cables
to the transaxle-shift arms
1. Shift arm (High to Low)
2. Shift arm (Second to Third) 4. Clevis pin
3. Loosen the clevis jam nuts and adjust each
clevis, so that the cable free play is equal
forward and backward relative to the hole in the
transaxle-shift arm (with the transaxle lever free
play taken up in the same direction).
4. Install the clevis pins and tighten the jam nuts
when finished.
45
position.
EUTRAL
(Figure 46).
Figure 46
3. Shift arm (First to Reverse)
g248309