Product Overview; Controls - Toro Workman HDX Series Operator's Manual

Product Overview

Controls

Note:
Determine the left and right sides of the
machine from the normal operating position.
Control Panel
1. Light switch
2. High-flow hydraulics
switch (TC models only)
3. Horn (TC models only)
4. Tachometer
5. Hour meter
6. Speedometer
7. Coolant-temperature
gauge and light
Accelerator Pedal
Use the accelerator pedal
speed of the machine when the transmission is in
gear. Pressing down the accelerator pedal increases
the engine speed and ground speed. Releasing the
pedal decreases the engine speed and ground speed.
Figure 5
8. Fuel gauge
9. Key switch
10. Power point
11. Supervisor switch
12. Oil-pressure-warning light
13. Charge indicator
14. 4-wheel drive switch
(4-wheel drive models
only)
(Figure 6) to vary the ground
1. Clutch pedal
2. Brake pedal
Clutch Pedal
g240583
You must fully press the clutch pedal
to disengage the clutch when starting the engine
or shifting transmission gears. Release the pedal
smoothly when the transmission is in gear to prevent
unnecessary wear on the transmission and other
related parts.
Important:
Do not ride the clutch pedal during
operation. The clutch pedal must be fully out or
the clutch slips, causing heat and wear. Never
hold the machine stopped on a hill using the
clutch pedal. Damage to the clutch may occur.
Brake Pedal
Use the brake pedal to stop or slow the machine
(Figure 6).
CAUTION
Operating a machine with worn or incorrectly
adjusted brakes can may result in personal
injury.
If the brake pedal travels to within 25 mm (1
inch) of the machine floor board, adjust or
repair the brakes.
13
Figure 6
3. Accelerator pedal
(Figure
g021226
6)