Fluke Expert Series User Manual page 31

Option Menu
Start Capture
Interval
Auto Capture
Image Count
Manual
Trigger
Temp Trigger
Set Temp
Trigger
Bluetooth
WiFi Hotspot
Wireless
WiFi Network
Shop for Fluke products online at:
Table 13. Camera Menu (cont.)
Option
Use Auto Capture settings to capture and save an infrared
image, or series of images, automatically.
Sets the number of hours, minutes, or seconds between image
captures.
The minimum interval available can be affected by
the file type and visible light camera settings. Some
combinations create larger file sizes that take longer
to capture and save and create a higher minimum
interval compared to others.
Sets a number of images to capture. Or, select Maximum
Memory to capture and save images until the chosen storage
memory is full or the battery runs out of power.
Select to automatically capture images when Start Capture is
selected.
Select to capture images when a value is above or below a set
temperature limit when Start Capture is selected.
With Temp Trigger selected, set the temperature and conditions
to trigger the auto capture of images.
Uses Bluetooth technology to connect the Imager to a device
such as a wireless headset. See Wireless Connectivity.
Uses the Imager to create a wireless Hotspot when no WiFi
network exists. See Wireless Connectivity.
Connects the Imager to a WiFi network so you can sign into your
Fluke Connect account on the Imager. See Wireless
Connectivity.
MyFlukeStore
www.
Expert Series Thermal Imagers
Description
Note
1.888.610.7664
.com
Menus
27