Fluke Expert Series User Manual page 28

TiX500, TiX520, TiX560, TiX580
Users Manual
MultiSharp Focus
MultiSharp Focus captures several images focused on multiple targets that are positioned at
different distances from the Imager and creates one image that focuses on the multiple targets
at the same time.
The minimum focus distance with MultiSharp Focus and a standard lens is 15 cm
(6 inches). For optimum performance, position the camera ≥23 cm (9 inches)
from the closest target. MultiSharp Focus also works with all compatible lenses.
To use:
1. Point the Imager at the target.
2. Capture an image. Hold the Imager still while it captures the images.
Saving... shows on the display for ∼2 seconds for a 60 Hz model or 5 seconds for a 9 Hz
model.
3. When Saving... no longer shows on the display, you can move the Imager. If necessary,
use a tripod to stabilize the Imager while the images save.
• In MultiSharp Focus mode, the Imager collects the images in the Imager and shows the
focused image on the display in ∼8 seconds for a 60 Hz model or ∼15 seconds for a
9 Hz model.
Confirm the image on the display is what you need. If possible, process the images on the
Imager.
• In MultiSharp Focus (In PC only) mode, the Imager collects the images in a single file
and shows the image on the display as it appears before you capture the image
(∼2 seconds for a 60 Hz model or ∼5 seconds for a 9 Hz model).
In MultiSharp Focus (In PC only) Mode, you cannot view the focused image on the Imager.
If possible, download, process, and view the image(s) on your computer while you are at
the job site. To view the focused image, open the image with SmartView software.
Some targets have abnormal thermal characteristics that can cause the
MultiSharp Focus algorithm to fail. If MultiSharp Focus mode does not capture a
clear image, use LaserSharp Auto Focus or Advanced manual focus.
24
Shop for Fluke products online at:
Note
Note
MyFlukeStore
www.
1.888.610.7664
.com