Electrical Interface; Overview; Electrical Warnings And Cautions; Control Box - Omron TM 12 Series Hardware Installation Manual

5. Electrical Interface

5.1 Overview

This chapter introduces all electrical interfaces of the robot arm and control box.

5.2 Electrical Warnings and Cautions

The application design and installation of the robot should comply with the following warnings.
DANGER:
1. Ensure all pieces of the equipment are kept dry. If water enters the equipment, disconnect
the power and contact your supplier.
2. Only use the original cables included with the robot. If you need longer cables, contact your
supplier.
3. Ensure that the robot is properly grounded. If the grounding is not correct, it may cause a
fire or electric shock.
WARNING:
The I/O cables used for the link between the control box and other equipment should not be
longer than 30 meters, unless testing shows that longer cables are feasible.

5.3 Control Box

WARNING:
Except for USB ports, other interfaces have to be installed while arm is powered off. Do not
install while arm is on to avoid abnormal shutdown.
Medium & Heavy Payload Series-Hardware Installation Manual TM12/14 Series

Figure 26: Control Box I/O Configuration (1/2)

Control Box I/O configuration
35