Table of Contents
Advertisement
FAX-L260i Chapter 3: Maintenance & Service
c) ERROR CODE LIST for FAX-L260i
New error codes indicate " new " in this list.
• User error code
No.
#001
#003
#005
#009
#011
#012
#018
#021
#022
#037
#080
#081
#082
#083
#084
#102
#995
• Service error code
D-channel error codes and B-channel error codes are not mentioned here. Please refer to item e).
No.
##100
##101
##102
##103
##104
##106
##107
##109
##111
##114
##200
##201
##204
##220
##223
##224
##226
Tx or Rx
Definition
[ TX
]
Paper Jam
[ TX/RX ]
Copy Page, Communication Time Over
[ TX/RX ]
Initial ID (T1) Time Over
[ RX
]
Recording Paper Jam or Out of Paper
[ RX
]
Polling Error
[ TX
]
Other party Out of Paper
[ TX/RX ]
Automatic Dialing Error
[ RX
]
DCN during Polling Rx
[ TX
]
Call Failure
[ RX
]
Image Memory Full
[TX
]
Other Party does not have ITU-T Recommended Subaddress Reception
Function
[TX
]
Other Party does not have ITU-T Recommended Password Reception
Function
[RX
]
Other Party does not have ITU-T Selective Polling Reception Function
[RX
]
Subaddress/Password disagreement when using ITU-T recommended
Selective Polling Reception
[RX
]
Other Party does not have ITU-T Recommended Password Reception
Function (When using Selective Polling Reception)
[TX/RX ]
Different Password during Password Transmission
[TX/RX ]
Memory Communication reservation cancellation
Tx or Rx
Definition
[ TX
]
Excessive Repeat Protocol during Rx
[ TX/RX ]
Modem Speed Different from Other Party
[ TX
]
Fall Back Failure during Tx
[ RX
]
Fail to Detect EOL for 5 Seconds (15 seconds for CBT) during Rx
[ TX
]
RTN or PIN Received during Tx
[ RX
]
Fail to Receive Protocol for 6 Seconds when Waiting for Protocol during
Rx
[ RX
]
Fall Back Failure on Tx Side during Rx
[ TX
]
Receive Signals Other than DIS, DTC, FTT, CFR or CRP after DCS Tx
and Exceed the Number of Protocol re-transmissions during Tx
[ TX/RX ]
Memory error
[ RX
]
RTN Transmission during Reception
[ RX
]
Fail to Detect Picture Rx Carrier for 5 Seconds during Rx
[ TX/RX ]
DCN received Other than Normal Binary Protocol
[ TX
]
Receive DTC without Tx Data
[ TX/RX ]
System Error (main program runaway)
[ TX
]
Line Disconnect during Communication
[ TX/RX ]
Abnormal Protocol during G3 Communication
[ TX/RX ]
Stack Pointer Not within RAM Range
3-14
- Quick Links:
- General Specification
Hide quick links:
Advertisement
Chapters
Table of Contents
