Configure The Touch Screen; Ethernet Setup - Crestron TSW-560 Supplemental Manual

Configure the Touch Screen

Ethernet Setup

On the Setup screen, tap Ethernet Setup to display the Ethernet Setup screen.
Ethernet Setup Screen
Use the Ethernet Setup screen to view the touch screen's MAC and IP addresses, subnet
mask, default router, primary and secondary DNS, hostname, and domain. This screen also
contains a Link indicator to show the status of the Ethernet connection. (Green indicates
that the Ethernet connection is active.)
DHCP can be enabled or disabled by tapping On or Off under DHCP Enable. When DHCP
is off, a Set Static IP Address Settings button provides access to controls that allow these
settings to be edited.
To change to a static IP address, tap Off under DHCP Enabled, and then tap Set Static IP
Address Settings to display the Static IP Ethernet Setup screen.
NOTE:
Supplemental Guide – DOC. 7927F
DHCP is enabled by default.
TSW-560/TSW-760/TSW-1060: 5", 7", and 10.1" Touch Screens • 3