Configure The Touch Screen - Crestron TSW-70 Series Product Manual

Configure the Touch Screen

When power is applied for the first time, the following screen is displayed. The touch screen may
take up to two minutes to boot.
Touch the screen to display the main Setup screen (TSW-1070 shown).
Device settings for the touch screen may be configured using the built-in setup screens or the
web configuration interface. For more information on configuring the touch screen, refer to
Configuration (on page 138).
Access the Device Setup Screens
To access the built-in setup screens, place five fingers on the display and hold for 15 seconds.
Use the setup screens to configure various settings for the touch screen, including Ethernet
setup, IP table setup, audio setup, display setup, standby timeout, application selection, Wi-Fi
network setup, diagnostics, the Bluetooth® beacon, and the virtual toolbar (model dependent).
Product Manual — Doc. 8550E TSW-70 Series • 103