Crestron TSW-570 Getting Started

TSW-570/TSW-770/TSW-1070
5 in., 7 in., and 10.1 in. Wall Mount Touch Screens
Getting Started
Scan the QR code to view the Quick Start Guide.
www.crestron.com/docs/8552
For additional information on the Crestron®
TSW-570/TSW-770/TSW-1070, visit the product page at
www.crestron.com.
Certification and Compliance
Regulatory Models: M201923001, M201923002, M201923003
Federal Communications Commission (FCC) Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is
subject to the following conditions:
(1) This device may not cause harmful interference and (2) this device
must accept any interference received, including interference that
may cause undesired operation.
CAUTION: Any changes or modifications not expressly approved by
the manufacturer responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
l
Increase the separation between the equipment and receiver.
l
Connect the equipment into an outlet on a circuit different from
l
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
l
Industry Canada (IC) Compliance Statement
CAN ICES-3 (B)/NMB-3(B)
As of the date of manufacture, the product has been tested and
found to comply with specifications for CE marking.
こ の装置は、 ク ラ ス B情報技術装置です。 こ の装置は、 家庭環境で使用 する こ と を 目的
と し て いま す力く こ の装置がラ ジオ やテ レ ビ ジョ ン 受信機に近接し て 使用さ れる と 、 受信障
害を 引き 起こ すこ と があり ま す。取扱説明書に 従っ て 正し い取り 扱いを し て 下さ い。
This is a class B product based on the standard of the VCCI Council.
If this is used near a radio or television receiver in a domestic
environment, it may cause radio interference. Install and use the
equipment according to the instruction manual.
IMPORTANT NOTE: To comply with FCC RF exposure compliance
requirements, the antenna used for this transmitter must be
installed to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operating in conjunction with
any other antenna or transmitter.
REMARQUE IMPORTANTE: Pour être conforme aux exigences de
conformité d'ISED CANADA et de la FCC en matière d'exposition aux
radiofréquences, l'antenne utilisée pour cet émetteur doit être
installée de manière à assurer une distance de séparation d'au moins
20 cm de toutes les personnes. toute autre antenne ou émetteur.
ISED Canada: This device contains licence-exempt transmitter
(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada's licence-exempt RSS(s). Operation is subject
to the following two conditions: 1. This device may not cause
interference. 2. This device must accept any interference, including
interference that may cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d'Innovation, Sciences et
Développement économique Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : 1. L'appareil ne doit pas produire de brouillage; 2.
L'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
The device meets the exemption from the routine evaluation limits in
section 2.5 of RSS 102 and compliance with RSS-102 RF exposure,
users can obtain Canadian information on RF exposure and
compliance.
Le dispositif rencontre l'exemption des limites courantes
d'évaluation dans la section 2.5 de RSS 102 et la conformité à
l'exposition de RSS-102 rf, utilisateurs peut obtenir l'information
canadienne sur l'exposition et la conformité de rf.
This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter. This equipment should be
installed and operated with a minimum distance of 20 centimeters
between the radiator and your body.
Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même
temps qu'aucune autre antenne ou émetteur. Cet équipement
devrait être installé et actionné avec une distance minimum de 20
centimètres entre le radiateur et votre corps.
The device for operation in the band 5150-5250 MHz is only for indoor
use to reduce the potential for harmful interference to co-channel
mobile satellite systems.
Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont
réservés uniquement pour une utilisation à l'intérieur afin de réduire
les risques de brouillage préjudiciable aux systèmes de satellites
mobiles utilisant les mêmes canaux;
Product Information - 8557CO
(2054677)
03.20