Kodak X-Omat 2000 Service Manual page 51

DEVELOPER FILTER
Important
Install a new DEVELOPER FILTER monthly or after approximately 1000 sheets of film have been processed.
CAP
O-RING
DEVELOPER
FILTER
FILTER
HOUSING
H172_1026CCA
H172_1026CC
Temperature of the Developer Solution
[1] Do the procedure on Page 29.
7C8772 – 12JAN99
[1] Soak the new DEVELOPER FILTER in warm
water for 30 seconds.
[2] Remove the FILTER AY.
[3] Lift the FILTER AY above the level of the
solutions.
Note
Keep the FILTER AY above the level of the solutions
during the procedure to prevent draining the solutions
from the TANKS.
[4] Disassemble:
• FILTER HOUSING
• DEVELOPER FILTER
• O-RING
• CAP
Important
The O-RING must be seated correctly.
[5] Assemble:
• FILTER HOUSING
• new DEVELOPER FILTER
• O-RING
• CAP
[6] Install the FILTER HOUSING in the
PROCESSOR.
[7] Check that the TUBING connected to the FILTER
HOUSING is not bent.
Periodic Maintenance
51