Kodak X-Omat 2000 Service Manual page 28

SERVICE MANUAL
[3] Disconnect from the 800 CIRCUIT BOARD:
(Not visible in the graphic)
• CONNECTOR 801
• CONNECTOR 802
[4] Disconnect from the ELECTRICAL BOX:
• TB2-1
• TB2-3
• TB2-5
• GROUND WIRE
[5] Remove:
• EXHAUST HOSE
• 6 MOUNTING SCREWS
• 4 SCREWS
• DRYER HEATER
[6] To install a new DRYER HEATER, reverse the steps above.
To install a new HEATER CORE, continue with Step 7.
[7] Loosen the 2 SCREWS.
[8] Remove the HEATER TOP COVER.
[9] Remove from inside the DRYER HEATER:
(Not visible in the graphic)
• 4 HEX NUTS
• 4 MOUNTING SCREWS
• HEATER CORE
[10] Reverse the steps to install the new HEATER CORE.
28 12JAN99 – 7C8772