Kodak X-Omat 2000 Service Manual page 49

DRYER
SPRING
GEAR
[1] Remove the DRYER RACK from the PROCESSOR.
[2] Check for broken GEARS and install new ROLLERS if necessary.
[3] Check the SPRINGS, not visible in the graphic, for correct tension and for wear. Install new SPRINGS if
necessary.
[4] Check and adjust the temperature of the DRYER. Use the procedure on Page 24.
MAIN DRIVE
DRIVE
CHAIN
SPROCKET
[1] Check the DRIVE CHAIN for wear and install a new DRIVE CHAIN if necessary.
[2] Check and adjust the tension of the DRIVE CHAIN. Use the procedure on Page 21.
[3] Lubricate the DRIVE CHAIN if necessary. Use the procedure on Page 53.
[4] Check for wear and install replacements if necessary:
• BEARINGS
• SPROCKETS
• WORM GEARS
[5] Check the TEETH of the SPROCKETS. If the TEETH are sharp, install new SPROCKETS.
[6] Check the WORM GEARS for burrs. Install new WORM GEARS if necessary.
[7] Rinse the WORM GEARS with warm water.
7C8772 – 12JAN99
ROLLER
WORM
GEAR
Periodic Maintenance
AIR TUBE
BEARING
H172_1059BCA
H172_1059BA
H172_1061BCA
H172_1061BA
49