Table of Contents
Advertisement
Basic System Configuration
1-2
Basic System Configuration
SYSMAC C200H/C200HS PC
24 VDC
Mixture
PID Control Unit Models
Number of Units
Number of Units Mountable
on Slave Rack
C200H-PID0j
PID Control Unit
Connecting cables:
C200H-CN225 (2 m)
C200H-CN425 (4 m)
Recommended cable:
ES1000-CA021-051 (0.5 m)
ES1000-CA021-102 (1 m)
ES1000-CA021-202 (2 m)
Loop 1
Loop 2
Air
Flow sensor
Valve
Output type
Model
The PID Control Unit belongs to the C200H Special I/O Unit group. A maximum
of ten Special I/O Units (including PC Link Units) can be mounted on the CPU
Rack, Expansion I/O Rack, and Slave Rack.
Note Configure the Units such that the maximum current supplied for each Rack is
greater than or equal to the total current consumption for the Units.
Refer to the C200H PC Operation Manuals for details on configuring systems.
The number of Special I/O Units used with a Slave Rack is limited by data trans-
mission considerations, as shown in the table below. The numbers in the table
Remote I/O Terminal or
Connector Terminal
Block Converter Unit
(Refer to page 15)
Relay box
Gas
Flow sensor
Valve
Transistor
output
C200H-PID01
Section 1-2
Data Setting Console
C200H-DSC01
Voltage output
Current output
C200H-PID02
C200H-PID03
3
Advertisement
Table of Contents
